![fujitsu fi 7160 clean fujitsu fi 7160 clean](https://www.fujitsu.com/global/Images/clean-ADF01_tcm100-1510539.gif)
Make sure that the rollers are cleaned properly because residue on them will affect the feeding performance.Īs a guideline, pressing the button seven times will rotate the feed/eject rollers one full turn.īe careful not to have your fingers caught when closing the ADF.Ĭonfirm that the ADF is closed completely. Wipe the dirt and dust off the whole surface by pressing the button to rotate the rollers. Put a piece of cloth moistened with Cleaner F1 or a sheet of Cleaning Wipe against the roller surface, and wipe horizontally.When you are cleaning the ADF, be careful not to touch the rollers with your hand while they are rotating. When you press the button, the feed/eject rollers rotate simultaneously. When you press the button, the feed/eject rollers rotate a certain amount.When you are cleaning the ADF, do not perform scanning with the scanner driver. Press the or button and select, then press the button to confirm.
![fujitsu fi 7160 clean fujitsu fi 7160 clean](https://www.pfuemea.com/assets/images/pages/products/scansnap/f1-scanner-cleaning-wipes-72-pack/con-cle-72-fujitsu-scanner-cleaning-wipes-contents-500.jpg)
The power must be turned on to rotate the feed/eject rollers for cleaning. If it is difficult to clean, use a cotton swab. Gently wipe the dirt and dust off the surface of the ultrasonic and document sensors. Ultrasonic Sensor (× 2)/Document Sensor (× 8) Vertical streaks may appear on scanned images if the glass is dirty. Gently wipe the dirt and dust off the surface of the glass sections. Make sure that it is cleaned properly because residue on the rollers will affect the feeding performance.īe careful not to damage the sponge on each roller. Gently wipe the dirt and dust off the roller, taking care not to damage the roller surface. Make sure that it is cleaned properly because residue on the rollers will affect the feeding performance. Gently wipe the dirt and dust off the grooves of the roller surface as you rotate the roller manually, taking care not to damage the roller surface. Gently wipe the dirt and dust off the grooves of the roller surface, taking care not to damage the roller surface.
#Fujitsu fi 7160 clean how to
Remove the brake roller from the scanner.įor details about how to remove the brake roller, refer to "(1) Replacing the Brake Roller" in "Replacing the Consumables". Clean the following locations with a cloth moistened with Cleaner F1, or a sheet of Cleaning Wipe.Pull the ADF release tab towards you to open the ADF.īe careful not to have your fingers caught when the ADF closes.Turn off the scanner and wait for at least 15 minutes.
![fujitsu fi 7160 clean fujitsu fi 7160 clean](https://m.media-amazon.com/images/S/aplus-media/sota/0b1da06e-5646-40f8-9243-fc12af5d0790._CR0,0,300,300_PT0_SX300__.jpg)
Wipe off the cleaner completely to leave no residue on the cleaned parts. It may take a long time to dry if an excessive amount of Cleaner F1 is used.Do not use water or mild detergent to clean the ADF.The inside of the ADF becomes very hot when the scanner is being used.īr/> Before you start cleaning the inside, make sure to turn off the power, unplug the power cable and wait at least 15 minutes for the ADF to cool down. CleaningĬlean the ADF in the following procedure: NOTE: this is an archived page and the content is likely to be out of date.